Red Dot Sight

VORTEX Optics Crossfire Red Dot 2 MOA Sight (CF-RD2)

VORTEX Optics Crossfire Red Dot 2 MOA Sight (CF-RD2)
VORTEX Optics Crossfire Red Dot 2 MOA Sight (CF-RD2)
VORTEX Optics Crossfire Red Dot 2 MOA Sight (CF-RD2)
VORTEX Optics Crossfire Red Dot 2 MOA Sight (CF-RD2)
VORTEX Optics Crossfire Red Dot 2 MOA Sight (CF-RD2)
VORTEX Optics Crossfire Red Dot 2 MOA Sight (CF-RD2)
VORTEX Optics Crossfire Red Dot 2 MOA Sight (CF-RD2)
VORTEX Optics Crossfire Red Dot 2 MOA Sight (CF-RD2)

VORTEX Optics Crossfire Red Dot 2 MOA Sight (CF-RD2)    VORTEX Optics Crossfire Red Dot 2 MOA Sight (CF-RD2)

Vortex Optics Crossfire Red Dot 2 MOA Red Dot. The 2 MOA dot is quick to acquire in close-quarters scenarios, while remaining fine enough to promote pin-point accuracy at extended range. In addition to looking awesome, the included skeletonized lower 1/3 co-witness mount provides a rock-solid and extremely lightweight platform for your red dot. The Crossfire is a no-nonsense sight for near any application.

The daylight bright red dot is easy to see and paints targets regardless of lighting conditions or background. The key thing to remember when shooting with the Crossfire Red Dot is to keep both of your eyes open! Shooting with both eyes open allows you to take full advantage of your peripheral vision to get on target very quickly.

Eye placement is not critical. The Crossfire Red Dot incorporates elevation and windage dials with audible clicks.

1 MOA will closely correspond to one inch at 100 yards, 1/2 inch at 50 yards, 1/4 inch at 25 yards, etc. Remove the turret cap and use the raised bar on the cover or a coin to turn the adjustment dial. Move the dials in the direction you wish the bullet's point-of-impact to change. Turning the elevation turret counter-clockwise will raise the elevation. Turning the windage turret clockwise will move the point of impact to the left.

Mounting the Crossfire Red Dot. The Crossfire Red Dot can be mounted on a variety of platforms using the high mount or low mount. Attach the unit to the rail/base with the illumination dial positioned on the right side. Make sure the mount is solidly seated in the base groove.

In order to prevent recoil injury, position the Red Dot so you have at least four inches of eye relief. Be sure the base clamp is hooked around the outside of the rail/base. Press the Red Dot downward and forward toward the muzzle.

Then, firmly tighten the base clamp bolt using the hex wrench.


VORTEX Optics Crossfire Red Dot 2 MOA Sight (CF-RD2)    VORTEX Optics Crossfire Red Dot 2 MOA Sight (CF-RD2)