ADE NUWA is the first(and the only)red dot with RMS/RMSc footprint that has TOP BATTERY LOADING system, no need to Remove the sight to change the Battery that requires re-sight in and waste ammo. Battery life approximately 500-800 depends on the brightness setting. Designed to fit Canik Elite TP9 SC, TP9 SFT, Canik Mete SFT, Taurus GX4 Toro, Sig P365XL/X, P365XL Spectre Comp, Ruger Max-9, S&W MP9 EZ, Kimber R7 Mako, S&W M&P9 shield plus Optics Ready, S&W M&P shield plus performance center, Mossberg MC2SC, Girsan MC1911SC Ultimate, Girsan/EAA Regard MC, Glock 43 MOS, Glock 48 MOS, Walther PPS M2 Optics Ready, Springfield XDS MOD 2 OSP, Springfield Elite 3.8 Compact OSP 9mm and Springfield Hellcat OSP or any pistol/mounting plate/slide with RMS/RMSC screw pattern/footprint. Hard coated aircraft aluminum and multi-coated glass.
Not plastic body with polymer lens. Weight approximately 15.5 grames(0.55oz), (Length)1.5 x (Width).. Comes with screws for several Optics Ready handguns. Does not comes with any mounting plate such as picatinny mount or plate made for a specific handgun. Ade Nuwa created an iron sight curve at the end of the body, and also added two white dots on the curve.
For the rear of part of the red dot to become a back up iron sight. With the ultra short design, the red dot provides a distance/gap on some full size optics ready pistols, to give enough distance to be a Co-Witness back up sight, in addition to the LED dot and pistol equipped iron sight.ADE Nuwa is manual activated by pressing the on/off switch. Press and Hold switch for 2 seconds to turn on/off, quick press to adjust the brightness from low to high. Comes with 3 pairs of screws for Sig P365XL/X, Springfield Hellcat OSP and Canik TP9 Elite SC ONLY. The provided screws might NOT work with EVERY compatible pistol listed. ADE makes the red dot to accept the industrial standard footprint. ADE Does not know the screw spec every pistol manufacture used for their screw hole. Please ask the pistol manufacture what screw specs they used on the hole and ask them to provide the screw. If you can't get the screw to work properly, we recommend going to a local hardware store such as ACE Hardware to get the right size.
ADE RD3-006B, RD3-009, RD3-012, and RD3-013 fit optic cut/plate that is compatible with Vortex Venom/Burris Fastfire/Doctor footprint. ADE RD3-018 Spike, RD3-021 Nuwa fit optic cut/plate that is compatible with Shield RMS/RMSC footprint. ADE RD3-019 Stingray, RD3-020 Raptor, RD3-023 Valkyrie Gen2 fit optic cut/optic plate that is compatible with Trijicon RMR footprint. We always reply emails within 8 hours. All NFA rules apply, where applicable.YOU are responsible to following ALL laws and regulations regarding the ownership, possession and end use of this item. This item is in the category "Sporting Goods\Hunting\Scopes, Optics & Lasers\Red Dot & Laser". The seller is "opticsfactory" and is located in this country: US. This item can be shipped to United States.